The Turas Bit Driver
This Turas is made of aged brass that was tumbled to give it a little extra character for contrast with a Micarta cap and features an owl themed grip that was laser engraved around the entire circumference. The engraving is deep enough to provide a very good grip for precision finger tip control as you manipulate the driver in your hands. This is currently a 1 of 1 design, I have not yet made any others with this pattern at this time.
Fully CNC Machined and then hand finished on a manual lathe.
Holds standard 1/4 bits securely
Approximately 3.1" long, bearing cap is 1" in diameter.
1/4 Hex broached in for keeping exact tolerances required.
Designed with ultimate grip in mind for breaking free pesky loc-tite on knife screws.
JTC Bearing has been installed under the cap.
Bit Driver Features magnet recessed in the pocket for retention of magnetic bits.
Proudly Made Right Here In Oregon!