The Turas Bit Driver

This Turas is made of Brass with a Micarta cap and features a Rose pattern grip that was laser engraved around the entire circumference. The engraving is deep enough to provide a very good grip for precision finger tip control as you manipulate the driver in your hands. This is currently at the time of its release a 1 of 1, I have not yet made any other drivers with this pattern. 

Features:

Fully CNC Machined and then hand finished on a manual lathe.

Holds standard 1/4 bits securely 

Approximately 3.1" long, bearing cap is 1" in diameter.

1/4 Hex broached in for keeping exact tolerances required.

Designed with ultimate grip in mind for breaking free pesky loc-tite on knife screws.

JTC Bearing has been installed under the cap. 

Hand Finished

Bit Driver Features magnet recessed in the pocket for retention of magnetic bits.

Proudly Made Right Here In Oregon!